Modeling a multiple-chain emeraldine gas sensor for NH₃ and NO₂ detection

• Hana Sustkova and
• Jan Voves

Beilstein J. Nanotechnol. 2022, 13, 721–729, doi:10.3762/bjnano.13.64

• good properties for NO2 detection. Keywords: ammonia; gas sensor; nitrogen dioxide; numerical computation; polyaniline; Introduction Polyaniline is a conducting polymer consisting of benzene rings connected by nitrogen units, which can be used in a wide spectrum of applications, for example, dyes for

Wet chemistry route for the decoration of carbon nanotubes with iron oxide nanoparticles for gas sensing

• Hussam M. Elnabawy,
• Juan Casanova-Chafer,
• Badawi Anis,
• Mostafa Fedawy,
• Mattia Scardamaglia,
• Carla Bittencourt,
• Ahmed S. G. Khalil,
• Eduard Llobet and
• Xavier Vilanova

Beilstein J. Nanotechnol. 2019, 10, 105–118, doi:10.3762/bjnano.10.10

• with iron oxide nanoparticles substantially ameliorated the response towards nitrogen dioxide. Keywords: benzene detection; doping; gas sensor; metal nanoparticle decoration; multiwalled carbon nanotubes; NO2 detection; room temperature gas sensing; surface modification; Introduction Carbon nanotubes

Gas-sensing behaviour of ZnO/diamond nanostructures

• Marina Davydova,
• Alexandr Laposa,
• Jiri Smarhak,
• Alexander Kromka,
• Neda Neykova,
• Josef Nahlik,
• Jiri Kroutil,
• Jan Drahokoupil and
• Jan Voves

Beilstein J. Nanotechnol. 2018, 9, 22–29, doi:10.3762/bjnano.9.4

• ]. Sadek et al. fabricated a ZnO nanobelt sensor and tested it for NO2 gas at operating temperatures between 150 and 450 °C. The optimum operating temperature for NO2 detection was in the range between 300 °C and 350 °C [25]. The sensing properties of various ZnO nanostructures (ZnO nanowires and ZnO–SnO2

Metal oxide nanostructures: preparation, characterization and functional applications as chemical sensors

• Dario Zappa,
• Angela Bertuna,
• Elisabetta Comini,
• Navpreet Kaur,
• Nicola Poli,
• Veronica Sberveglieri and
• Giorgio Sberveglieri

Beilstein J. Nanotechnol. 2017, 8, 1205–1217, doi:10.3762/bjnano.8.122

• detect concentrations of carbon monoxide lower than 10 ppm. Therefore tin-oxide-based devices are ideal candidates. On the contrary, NiO performs much better than other oxides for NO2 detection, especially at low concentrations (below 10 ppm). European Union (EU) Air quality Standards require the average

Study of the correlation between sensing performance and surface morphology of inkjet-printed aqueous graphene-based chemiresistors for NO₂ detection

• F. Villani,
• C. Schiattarella,
• T. Polichetti,
• R. Di Capua,
• F. Loffredo,
• B. Alfano,
• M. L. Miglietta,
• E. Massera,
• L. Verdoliva and
• G. Di Francia

Beilstein J. Nanotechnol. 2017, 8, 1023–1031, doi:10.3762/bjnano.8.103

CVD transfer-free graphene for sensing applications

• Chiara Schiattarella,
• Sten Vollebregt,
• Tiziana Polichetti,
• Brigida Alfano,
• Ettore Massera,
• Maria Lucia Miglietta,
• Girolamo Di Francia and
• Pasqualina Maria Sarro

Beilstein J. Nanotechnol. 2017, 8, 1015–1022, doi:10.3762/bjnano.8.102

• examined devices a different behaviour can be distinguished for the two analytes, in particular αNO2 ≈ 5αNH3 has been found, showing a predisposition of the sensing material towards NO2 detection (Table 1 and Table 2). Finally, the characteristic energies related to the interaction between graphene and NO2

• analyte adsorption rather than the kinetics of the surface reactions. From this analysis a predisposition of transfer-free CVD graphene towards NO2 detection has clearly emerged. The remarkable control on the sensing film geometry, which is specific to the presented technique, enables a quantification of

Gas sensing properties of MWCNT layers electrochemically decorated with Au and Pd nanoparticles

• Elena Dilonardo,
• Michele Penza,
• Marco Alvisi,
• Riccardo Rossi,
• Gennaro Cassano,
• Cinzia Di Franco,
• Francesco Palmisano,
• Luisa Torsi and
• Nicola Cioffi

Beilstein J. Nanotechnol. 2017, 8, 592–603, doi:10.3762/bjnano.8.64

• covers MWCNT sidewalls as shown in Figure 4E. In the following section, the effect of the nature and loading of the deposited catalytic metal NPs on the gas sensing properties of MWCNTs is discussed. Gas sensing properties The effect of the working temperature in the range 45–200 °C on NO2 detection is

Evaluation of gas-sensing properties of ZnO nanostructures electrochemically doped with Au nanophases

• Elena Dilonardo,
• Michele Penza,
• Marco Alvisi,
• Cinzia Di Franco,
• Francesco Palmisano,
• Luisa Torsi and
• Nicola Cioffi

Beilstein J. Nanotechnol. 2016, 7, 22–31, doi:10.3762/bjnano.7.3

• temperatures. For samples annealed at 300 °C, the presence of Au NPs did not improve the gas sensing properties, instead it reduced the sensitivity of ZnO. In contrast, the ZnO sensitivity was improved in Au-doped nanocomposites annealed at 550 °C, allowing the NO2 detection down to a concentration of 0.2 ppm

• sensing response of pristine and Au-doped ZnO nanostructures were strongly influenced by the annealing temperature. Similarly to the trend reported for NO2 detection, for samples annealed at 300 °C, the presence of Au NPs did not improve the gas-sensing properties, instead the sensitivity of ZnO decreased

Pt- and Pd-decorated MWCNTs for vapour and gas detection at room temperature

• Hamdi Baccar,
• Atef Thamri,
• Pierrick Clément,
• Eduard Llobet and
• Adnane Abdelghani

Beilstein J. Nanotechnol. 2015, 6, 919–927, doi:10.3762/bjnano.6.95

• -treated carbon nanotubes with Au or Ag using an evaporation technique for NO2 detection at room temperature [29]; however, their sensors were not fully reversible. Penza and co-workers decorated CVD grown carbon nanotubes with Au, Pt or Pd by using sputtering to enhance sensor response towards NO2 and NH3

Advances in NO₂ sensing with individual single-walled carbon nanotube transistors

• Kiran Chikkadi,
• Matthias Muoth,
• Cosmin Roman,
• Miroslav Haluska and
• Christofer Hierold

Beilstein J. Nanotechnol. 2014, 5, 2179–2191, doi:10.3762/bjnano.5.227

• also appeared to be highly sensitive even without optimization, hinting at their promise for NO2 detection. Several studies, both experimental and theoretical, have been conducted to understand the effect of gas molecules on carbon nanotube devices. Understanding the effect of gases on the CNFET